icShop Logo
Welcome, ( 登入 or 註冊 )
 
0

CATEGORIES

商業月結申請
CIRCIS Pi
創客萊吧 MakerLab
line@

USB DC-DC 升壓模組 (0.9V~5V)
$ 18.0 元


U3V12F9升壓模組9V(Pololu)【限量6個】
貨號:368030700168
售價 : NT
$ 160.0 元
$ 89.0 元
製造商 :Pololu
產地: 0
適用運送方式 : 7-11取貨付款,7-11純取貨,郵寄(單一運費),貨運,宅配,貨到付款,7
出貨時程: 數量有限,售完為止,不再追加。   


輸入數量 :
Add to wish list
產品上架時間 2013 九月 05 週四.
規格內容說明  

Overview

These boost (step-up) voltage regulators generate higher output voltages from input voltages as low as 2.5 V. They are switching regulators (also called switched-mode power supplies (SMPS) or DC-to-DC converters) and have a typical efficiency between 80% to 90%. The available output current is a function of the input voltage, output voltage, and efficiency (see Typical Efficiency and Output Current section below), but the input current can typically be as high as 1.4 A. This regulator is available with a fixed 5 V, 9 V, or 12 V output:
The regulator’s thermal shutdown prevents damage from overheating, but it does not have short-circuit or reverse-voltage protection.

Features

  • input voltage: 2.5 V – VOUT
  • fixed 5 V, 9 V, or 12 V output with 4% accuracy
  • 1.4 A switch allows for input currents up to 1.4 A
  • 2 mA typical no-load quiescent current
  • integrated over-temperature shutoff
  • small size: 0.515″ × 0.32″ × 0.1″ (13 × 8 × 3 mm)

Using the Regulator

Connections

The boost regulator has three connections: input voltage (VIN), ground (GND), and output voltage (VOUT).
The input voltage, VIN, must be at least 2.5 V and should not exceed the output voltage, VOUT. Please be wary of destructive LC spikes that might cause the input voltage to exceed VOUT (see below for more information).
The three connections are labeled on the back side of the PCB, and they are arranged with a 0.1″ spacing along the edge of the board for compatibility with solderless breadboards, connectors, and other prototyping arrangements that use a 0.1″ grid. You can solder wires directly to the board or solder in either the 3×1 straight male header strip or the 3×1 right-angle male header strip that is included.

Typical Efficiency and Output Current

The efficiency of a voltage regulator, defined as (Power out)/(Power in), is an important measure of its performance, especially when battery life or heat are concerns. As shown in the graphs below, this switching regulator typically has an efficiency of 80 to 90%.

The maximum achievable output current is approximately proportional to the ratio of the input voltage to the output voltage. If the input current exceeds the switch current limit (typically somewhere between 1.4 and 2 A), the output voltage will begin to drop. Additionally, the maximum output current can depend on other factors, including the ambient temperature, air flow, and heat sinking.

LC Voltage Spikes

When connecting voltage to electronic circuits, the initial rush of current can cause damaging voltage spikes that are much higher than the input voltage. In our tests with typical power leads (~30″ test clips), input voltages above 10 V caused voltage spikes in excess of 20 V. You can suppress such spikes by soldering a 33μF or larger electrolytic capacitor close to the regulator between VIN and GND.
More information about LC spikes can be found in our application note, Understanding Destructive LC Voltage Spikes.

Dimensions

Size:

0.32″ × 0.515″ × 0.1″1

Weight:

0.4 g1

General specifications

Minimum operating voltage:

2.5 V

Maximum operating voltage:

9 V

Maximum input current:

1.5 A2

Output voltage:

9 V

Reverse voltage protection?:

N

Maximum quiescent current:

2 mA

Notes:

1
Without included optional headers.
2
Regulator may overheat at lower input currents when VIN is much lower than VOUT. Available output current is a function of VIN, VOUT, and the regulator efficiency.

 

參考資料下載  

詳見更多圖文

其它相關資訊  






 


MCP73831T-2ACI/OT
SINGLE CELL LI-LON/LI-POLYMER CHG MGMT SYSTEMS
$ 28.0 元
1 x 'MCP73831T-2ACI/OT'
Pololu 9V 升/降壓穩壓器 S10V3F9【限量2個】
IN:2.5V~18V ,OUT:9V

$ 160.0 元
$ 99.0 元
1 x 'Pololu 9V 升/降壓穩壓器 S10V3F9【限量2個】'
MicroUSB LiIon/LiPoly charger-V1(3.7V or 4.2V)
鋰電池充電板,充電模組,充電模塊
$ 299.0 元
1 x 'MicroUSB LiIon/LiPoly charger-V1(3.7V or 4.2V)'
HC-05 主從一體 藍牙模組
Arduino 原廠正品/Bluetooth 串口
$ 120.0 元
1 x 'HC-05 主從一體 藍牙模組'
10條-彩色杜邦雙頭線(公/母 )/20 cm
杜邦線 公對母 彩色線 2.54mm 連接線 樹莓派 Raspberry Pi
12股 銅絲 含膠殼 排線 麵包線

$ 9.0 元
1 x '10條-彩色杜邦雙頭線(公/母 )/20 cm'
USB 連接器 A type 母 (扁) 90度 FOR PCB
連接座 母座 彎腳
$ 10.0 元
1 x 'USB 連接器 A type 母 (扁) 90度 FOR PCB'
40條-彩色杜邦雙頭線(母/公 )/10 cm
10cm 杜邦線 公對母 彩色線 40p 杜邦端子 連接線
$ 32.0 元
1 x '40條-彩色杜邦雙頭線(母/公 )/10 cm'
麵包板連接線(65±2條)
杜邦線 連接線 轉接線 雙公頭 面包線 跳線 測試線 實驗線 arduino
$ 35.0 元
1 x '麵包板連接線(65±2條)'